Henriette Firepit February 24th, 2018 - 19:18:05
Also, if you live in a condo or other planned community there may be restrictions to what you can have installed in your yard area. Check with your insurance company and HOA or board to see if any regulations prevent you from setting up something. If nothing stands in the way of your plan to enhance your backyard relaxation, you next want to research what kind of pit you want. Do you have an existing deck or patio? You may be able to build onto it and install a gas line for it. If not, you may wish to landscape the backyard altogether with the firepit as the focus. A local contractor or backyard leisure store can offer you many ideas.
Your next step is to start digging! Since youve already decided on the size of your firepit, all you have to do is dig an appropriately sized hole. Next, use bricks of the same height and place them at the surface level of the pit. From there, begin creating simple stacked rows, making sure to offset the vertical joints of each brick. When your pit has reached your desired and pre-planned height, youre ready to move on to the next step. Support the bricks you have laid by adding firmly packed soil around the area. You can also use gravel for the floor of the pit, smoothing as you add it in. Your final step is to add in top caps to the walls.
When you buy a new copper firepit there are some safety issues that you will want to follow. One of the most important things to keep in mind is the weather. If your area has issued a fire warning of any type you wont want to start a fire outdoors. In dry areas it is better to be safe than to be sorry. If there is no fire warning remember also that you need to keep your fire under control. Make sure that your fire doesnt get too big, and keep a screen on the firepit so that there wont be any burning embers or ashes flying away from the fire.
Procedure: First, we excavated a pit approximately 1metre (3 feet) in diameter and 800mm deep. The ground we were working on was very rocky so we used a backhoe and it was difficult to carve a smooth hole as you can see by the photos. Next we dug a drainage channel from the bottom of the hole to a lower point beyond the extent of the fire area. This was essential in this circumstance due to the heavy rainfall and the heavy soil. If your soil is porous it may not be necessary to provide drainage to the pit. In the channel we laid the plastic drainage pipe and covered it with gravel. Because we wanted to line the pit with the 600mm granite slabs we placed extra gravel in the bottom of the pit to set the stones on upright in a circle.