Henriette Firepit February 23rd, 2018 - 11:09:15
Seat distance from the firepit is critical. Too close and the fire will be too hot; too far away and the heat wont reach you. You can vary the distance with each seat but we found that for a pit 800mm in diameter the seats should be about 1m away from the pit. This allows people to walk in front of each other around the fire. Once the rock seats are in place the next job was to pour concrete around the pit and around the bottom of the seats so that the outside line of concrete joins all the stones about halfway. The back of the rocks protrudes out into what will become turf.
Firepit Tools: These tools are mainly used to tend the fires. You can buy a set or can just order fire poker and a pair of tongs, used for tending the fire and to move the logs, if they have been used to light the fire. Outdoor Firepit Screens: These screens are wire mesh devices attached to the outer edge of the outdoor firepit. The mesh is used to prevent fire and ashes from spilling out of the pit. There are various designs that you can get with the meshes. These meshes can be used in different ways when the pit is turned into an oven. You can feel the heat while keeping safe.
Fire lit areas are a welcome addition for any group, whether it is a casual group of friends, a reunion or even a business meeting. The dim lighting paired with the flickering light of a flame, encourages open communication and good spirits. For a commercial area, gas firepits will be the most obvious choice. They do not have to be maintained by staff, and will keep a flame up for as long as guests are there. Finding the Right Style Because you will be using a gas firepit, the styles you have to choose from are almost endless. For rustic settings, there are wood-look pits that are incredibly realistic. In settings that are modern or settings that you want to look more surreal, there are pits that have fire floating above blue surfaces or burning amidst a pile of smooth rocks. Any of these styles come in small to very large sizes.
Its a bit tricky to get the heavy slabs in an exact circle with a consistent height but its best to prop them up and backfill with the gravel so that each stone is buried 150mm leaving a 450mm deep pit. The top of the granite should be 200mm above the surrounding ground level to allow for the concrete slab and paving. You could cut each stone lengthwise along one edge to make them fit flush with each other but it isnt necessary. The bottom of the pit was then paved to make shovelling out the ashes easier.