Henriette Firepit February 23rd, 2018 - 10:58:25
Once the stone lining was completed we used an excavator to place the large stone seats. Depending on the size of the stones they may have to be dug into the ground or set higher on gravel to give them an approximately consistent height. Bearing in mind that a comfortable adult seat height should be 300 - 400mm the stones need to conform to this measurement. By the time the concrete is poured and the paving laid the finished ground height will be 150mm higher than existing ground level, meaning that the rocks should stand 450 - 550mm above the ground.
Once youve figured out just what to do with the hole, lets look at some decorative edging. Again you can opt to just leave the sides bare. Leaving a gaping hole in the ground probably isnt the greatest idea, someone could trip and fall into the pit. So here are some edging options going again from least to most expensive. Use the dirt that you excavated from the pit to build a berm around the edge of the pit. Like with leaving the hole unlined, youll have to worry about wash out. The next method is to place large rounded stones around the perimeter. The stones can get expensive but youll only need a couple dozen to finish off the edge.
Your first step is, of course, to choose where your firepit will go. Pick an area that doesnt present a fire hazard and that will be comfortable for you and your guests to sit and relax. If, for example, you know one part of your yard is prone to mosquitoes, you would certainly want to avoid that spot. Just think practically, and you should be fine! When youve decided on the size and location of your pit, mark it using chalk or paint. If there is sod in the area, youll need to remove it, and you should also use a pre-emergent herbicide in order to prevent grass from growing in that area again.
So, on the different designs. One of the most common is a large bowl, usually metal, but sometimes ceramic, set on legs. You just set this up where you want you fire and you are good to go. Added features can include wheels, covers, screens and even grills for cooking. A nice twist on this design is the fire pit table, which adds are table-like ring around the outside of the pit. You can think of these as an outdoor table with a fire-pit built in. You have probably also seen a chiminea, which is more like a self-standing fireplace. These generally only have only one or two openings, rather than being open all around. While the classic chiminea is made from ceramic or terra cotta, they also come in copper or cast-iron.