Anastasia Landry Firepit February 19th, 2018 - 10:17:12
The style is important too, as it should fit the style of the wedding. There are casual design pits as well as modern and more formal. If youre grilling, there are outdoor fireplaces that allow for cooking, and table style pits that give you space right beside the fire to keep drinks and utensils. Choose a design and size that works for your number of guests. Most pits allow access from any side, which is ideal in this type of large gathering. The number of guests will dictate the size or number you will need. Decide if you want one or two large pits, or several smaller pits. This will depend on the number of guests and the possibility of family members that may not get along. In the latter case, youll definitely want more pits in order to keep certain guests separate.
So, on the different designs. One of the most common is a large bowl, usually metal, but sometimes ceramic, set on legs. You just set this up where you want you fire and you are good to go. Added features can include wheels, covers, screens and even grills for cooking. A nice twist on this design is the fire pit table, which adds are table-like ring around the outside of the pit. You can think of these as an outdoor table with a fire-pit built in. You have probably also seen a chiminea, which is more like a self-standing fireplace. These generally only have only one or two openings, rather than being open all around. While the classic chiminea is made from ceramic or terra cotta, they also come in copper or cast-iron.
Procedure: First, we excavated a pit approximately 1metre (3 feet) in diameter and 800mm deep. The ground we were working on was very rocky so we used a backhoe and it was difficult to carve a smooth hole as you can see by the photos. Next we dug a drainage channel from the bottom of the hole to a lower point beyond the extent of the fire area. This was essential in this circumstance due to the heavy rainfall and the heavy soil. If your soil is porous it may not be necessary to provide drainage to the pit. In the channel we laid the plastic drainage pipe and covered it with gravel. Because we wanted to line the pit with the 600mm granite slabs we placed extra gravel in the bottom of the pit to set the stones on upright in a circle.
Once youve figured out just what to do with the hole, lets look at some decorative edging. Again you can opt to just leave the sides bare. Leaving a gaping hole in the ground probably isnt the greatest idea, someone could trip and fall into the pit. So here are some edging options going again from least to most expensive. Use the dirt that you excavated from the pit to build a berm around the edge of the pit. Like with leaving the hole unlined, youll have to worry about wash out. The next method is to place large rounded stones around the perimeter. The stones can get expensive but youll only need a couple dozen to finish off the edge.