Anastasia Landry Firepit February 19th, 2018 - 10:17:01
Its a bit tricky to get the heavy slabs in an exact circle with a consistent height but its best to prop them up and backfill with the gravel so that each stone is buried 150mm leaving a 450mm deep pit. The top of the granite should be 200mm above the surrounding ground level to allow for the concrete slab and paving. You could cut each stone lengthwise along one edge to make them fit flush with each other but it isnt necessary. The bottom of the pit was then paved to make shovelling out the ashes easier.
You will want to use an appropriate adhesive material, such as mortar, to keep the caps firmly in place. Be sure to apply the caps only to dry surfaces and to keep them level during the process. Believe it or not, once youve done this, youre ready to try out your new firepit! Make sure to take proper care of your firepit so that you can enjoy it for many years to come. Always clean the ashes from your pit one day after use. If you have decided to paint your pit (using fire resistant paint, of course), it may need touch-ups from time to time to continue looking its best. Make sure that water is never used to put out fires, as this can cause the firepit to break down faster. Youll also want to invest in a good firepit cover for when the pit is not in use.
When you buy a new copper firepit there are some safety issues that you will want to follow. One of the most important things to keep in mind is the weather. If your area has issued a fire warning of any type you wont want to start a fire outdoors. In dry areas it is better to be safe than to be sorry. If there is no fire warning remember also that you need to keep your fire under control. Make sure that your fire doesnt get too big, and keep a screen on the firepit so that there wont be any burning embers or ashes flying away from the fire.
Your first step is, of course, to choose where your firepit will go. Pick an area that doesnt present a fire hazard and that will be comfortable for you and your guests to sit and relax. If, for example, you know one part of your yard is prone to mosquitoes, you would certainly want to avoid that spot. Just think practically, and you should be fine! When youve decided on the size and location of your pit, mark it using chalk or paint. If there is sod in the area, youll need to remove it, and you should also use a pre-emergent herbicide in order to prevent grass from growing in that area again.