Henriette Firepit February 21st, 2018 - 11:09:11
Your next step is to start digging! Since youve already decided on the size of your firepit, all you have to do is dig an appropriately sized hole. Next, use bricks of the same height and place them at the surface level of the pit. From there, begin creating simple stacked rows, making sure to offset the vertical joints of each brick. When your pit has reached your desired and pre-planned height, youre ready to move on to the next step. Support the bricks you have laid by adding firmly packed soil around the area. You can also use gravel for the floor of the pit, smoothing as you add it in. Your final step is to add in top caps to the walls.
You will want to use an appropriate adhesive material, such as mortar, to keep the caps firmly in place. Be sure to apply the caps only to dry surfaces and to keep them level during the process. Believe it or not, once youve done this, youre ready to try out your new firepit! Make sure to take proper care of your firepit so that you can enjoy it for many years to come. Always clean the ashes from your pit one day after use. If you have decided to paint your pit (using fire resistant paint, of course), it may need touch-ups from time to time to continue looking its best. Make sure that water is never used to put out fires, as this can cause the firepit to break down faster. Youll also want to invest in a good firepit cover for when the pit is not in use.
Procedure: First, we excavated a pit approximately 1metre (3 feet) in diameter and 800mm deep. The ground we were working on was very rocky so we used a backhoe and it was difficult to carve a smooth hole as you can see by the photos. Next we dug a drainage channel from the bottom of the hole to a lower point beyond the extent of the fire area. This was essential in this circumstance due to the heavy rainfall and the heavy soil. If your soil is porous it may not be necessary to provide drainage to the pit. In the channel we laid the plastic drainage pipe and covered it with gravel. Because we wanted to line the pit with the 600mm granite slabs we placed extra gravel in the bottom of the pit to set the stones on upright in a circle.
So, on the different designs. One of the most common is a large bowl, usually metal, but sometimes ceramic, set on legs. You just set this up where you want you fire and you are good to go. Added features can include wheels, covers, screens and even grills for cooking. A nice twist on this design is the fire pit table, which adds are table-like ring around the outside of the pit. You can think of these as an outdoor table with a fire-pit built in. You have probably also seen a chiminea, which is more like a self-standing fireplace. These generally only have only one or two openings, rather than being open all around. While the classic chiminea is made from ceramic or terra cotta, they also come in copper or cast-iron.