Henriette Fireplace November 02nd, 2017 - 12:21:50
If you decide that sitting next to the fireplace is the way to go, you will need to make sure you have enough chimney rods to span the entire length of your chimney. As you are sitting next to your fireplace, push your brush up through the flue. Continue to add more brush rods as needed until the brush is at the top of the chimney. As you pull the brush back down, you will need to make a back and forth motion to really scrub the creosote off the walls of the chimney. Be sure to shield your eyes, as some of this loosened creosote may fall into the firebox.
The Purpose of the Fireplace There are different reasons as to why you would need an electric fireplace and one of them can be to warm a living room or a particular room in the house. Therefore, chances are that you could end up having to choose between an electric heater and an electric fireplace. The truth is that both are quite demanding when it comes to electricity consumption and most the time, you cannot rely on an electric fireplace as a main source of heat. In fact, there are no assurances that the fireplace will increase the value of any home. In other words, electric fireplaces can have the best aesthetic value to any home whereby you can still use it to mimic the traditional fireplace without having it warm up the house. On the other hand, you also need to weigh the effectiveness of having such equipment in your home.
There are three different styles of gas fireplaces: the direct vent model, the top vent design, and the vent-free model. The direct vent gas fireplace uses two vent pipes that lead directly to the outside. One pipe uses combustion air from the outside while the other vents the exhaust gas. The top vent gas fireplace design can be installed into existing fireplaces and uses the metal or brick chimney as the exhaust vent. The combustion air for top vent fireplaces is drawn from inside the home while the chimney vents the exhaust gas. The vent-free gas fireplace model uses no exhaust vent. This style includes an oxygen-depletion sensor that turns off the gas if it senses a dangerous lack of oxygen inside the house. While fireplace manufacturers claim that vent-free fireplaces burn clean, are energy-efficient and dont threaten indoor air quality, be aware that a number of states do not permit the installation of vent-free fireplaces. In the New England states of New Hampshire, Massachusetts, Vermont, Maine and Connecticut installation of vent-free gas fireplaces is permitted. Massachusetts has in the past not authorized the installation of vent free gas fireplaces for safety reasons.
While these screens will not stop a rolling log they will protect areas outside the hearth from flying sparks from popping wood sap. One of the greatest advantages to mesh screens is that they require no extra space or braces and do not extend past the flush face of the fireplace. Another very common type of fireplace screen is made of iron, brass or steel and mounts in front of or on the hearth free-standing in front of the firebox. These fireplace screens can be a simple flat screen, might be free standing on leg-brackets and could be the more common three-sided screen. Three-sided screens have a center section that spans the width of the fireplace. The two sides are hinged to turn at a thirty to forty-five degree angle thus holding the screen plum straight up. The fireplace screen can have fireplace tools, candles and all manner of artistic décor built into the design.