Henriette Fireplace February 15th, 2018 - 11:58:26
Pellet fireplace inserts use wood pellets or other types of pellets (corn based, soy based, etc.) as the fuel source. Pellet fireplace inserts come with fans or blowers that automatically circulate the heat. Pellet-Burning Hearth Appliances Pellet-burning hearth appliances are simpler to operate and more convenient than other wood-burning appliances. In fact, they are almost as easy to use as gas, oil or electric heaters. Pellet stoves and pellet inserts burn wood pellets or compressed wood. Pellet-burning hearth appliances are loaded with pellets through a hopper and the rate of burn is controlled by an electronic circuit board that is typically controlled by burn settings or a thermostat. Most pellet appliances have at least two burn settings and some new models use thermostats to control the fire.
Cast Iron Fireplaces Those who have homes with very little room for a fireplace will like the cast iron fireplaces. This type can be put up in a home using just a cement slab, the size of the fireplace and a fire proof stone wall at the back. It will require venting into a chimney, or outside, according to your municipal codes. Cast iron fireplaces and stoves are perfect for small areas. Cast iron fireplaces create a smokeless fuel fire so they are appropriate for interiors. Traditional Fireplaces The most recognizable type of fireplace is the typical "wall-mounted" design found in living rooms, dens, and even bedrooms. It may be consisted of brick, cement, stone, ceramic, or some mixture of these materials. The opening will typically be covered with a metal or glass screen of some type. Fireplaces of this kind often are surrounded by an exterior mantle, which can be made of wood, stone, brick, marble, metal, or some other material. Mantle styles can vary from unadorned to stylish to ornate to fanciful. Due to their importance, they often set the decorative tone for the whole room. Mostly they use wood for fuel, but some can also burn peat, coal, and other materials. Fireplaces of this type are not for the most part energy-efficient.
If you decide that sitting next to the fireplace is the way to go, you will need to make sure you have enough chimney rods to span the entire length of your chimney. As you are sitting next to your fireplace, push your brush up through the flue. Continue to add more brush rods as needed until the brush is at the top of the chimney. As you pull the brush back down, you will need to make a back and forth motion to really scrub the creosote off the walls of the chimney. Be sure to shield your eyes, as some of this loosened creosote may fall into the firebox.
There are three different styles of gas fireplaces: the direct vent model, the top vent design, and the vent-free model. The direct vent gas fireplace uses two vent pipes that lead directly to the outside. One pipe uses combustion air from the outside while the other vents the exhaust gas. The top vent gas fireplace design can be installed into existing fireplaces and uses the metal or brick chimney as the exhaust vent. The combustion air for top vent fireplaces is drawn from inside the home while the chimney vents the exhaust gas. The vent-free gas fireplace model uses no exhaust vent. This style includes an oxygen-depletion sensor that turns off the gas if it senses a dangerous lack of oxygen inside the house. While fireplace manufacturers claim that vent-free fireplaces burn clean, are energy-efficient and dont threaten indoor air quality, be aware that a number of states do not permit the installation of vent-free fireplaces. In the New England states of New Hampshire, Massachusetts, Vermont, Maine and Connecticut installation of vent-free gas fireplaces is permitted. Massachusetts has in the past not authorized the installation of vent free gas fireplaces for safety reasons.