Henriette Fireplace February 09th, 2018 - 12:19:16
5. Put Your Fireplace Candelabra on Your Mantel - For those of us who have gas or electric fireplaces, and do not wish to remove the fake logs during the warm season, consider placing a candelabrum or two on your mantel. This is actually a very classic way of decorating your fireplace. Use fireplace candelabra that are made for smaller fireplaces or zero clearance fireplaces. 6. Put Your Fireplace Candelabra on Your Hearth - If you do not have a mantel, you can place your fireplace candelabra on your hearth just as easily. Be sure to add a little greenery in the spring, maybe a sting of fall leaves in the autumn and some pine needles and cones in the winter for an added special touch.
There are three different styles of gas fireplaces: the direct vent model, the top vent design, and the vent-free model. The direct vent gas fireplace uses two vent pipes that lead directly to the outside. One pipe uses combustion air from the outside while the other vents the exhaust gas. The top vent gas fireplace design can be installed into existing fireplaces and uses the metal or brick chimney as the exhaust vent. The combustion air for top vent fireplaces is drawn from inside the home while the chimney vents the exhaust gas. The vent-free gas fireplace model uses no exhaust vent. This style includes an oxygen-depletion sensor that turns off the gas if it senses a dangerous lack of oxygen inside the house. While fireplace manufacturers claim that vent-free fireplaces burn clean, are energy-efficient and dont threaten indoor air quality, be aware that a number of states do not permit the installation of vent-free fireplaces. In the New England states of New Hampshire, Massachusetts, Vermont, Maine and Connecticut installation of vent-free gas fireplaces is permitted. Massachusetts has in the past not authorized the installation of vent free gas fireplaces for safety reasons.
While these screens will not stop a rolling log they will protect areas outside the hearth from flying sparks from popping wood sap. One of the greatest advantages to mesh screens is that they require no extra space or braces and do not extend past the flush face of the fireplace. Another very common type of fireplace screen is made of iron, brass or steel and mounts in front of or on the hearth free-standing in front of the firebox. These fireplace screens can be a simple flat screen, might be free standing on leg-brackets and could be the more common three-sided screen. Three-sided screens have a center section that spans the width of the fireplace. The two sides are hinged to turn at a thirty to forty-five degree angle thus holding the screen plum straight up. The fireplace screen can have fireplace tools, candles and all manner of artistic décor built into the design.
The next step is to clean those well-used fireplace tools and fireplace grate. Black soot and resin can easily build up on your tools and can make them unsightly and grungy-looking. Here are a few simple steps to help bring back their original luster and shine. Take your fireplace grate and tools outside and give them a good hosing down. This will quickly remove all of the loose soot and dirt from the surface. For the fireplace grate, fill a bucket with hot water and a small amount of abrasive cleaner. Scrub with a steel wool pad to remove the caked on resin and soot. You may need to use a stiff-bristled brush to get the really bad parts. For the fireplace tools, use hot water and a small amount of ammonia cleaner. Avoid using abrasives, as these may scratch the finish on your tools. You may use a scrub brush to get the stubborn dirt particles, but use caution so as not to damage the surface.