Henriette Firepit February 22nd, 2018 - 10:32:24
As they are portable, outdoor firepits are easy to move from one place to another. You can carry your set to a picnic spot far from home without much difficulty. There are various accessories that can come with an outdoor firepit. You can buy them to enhance the safety and beauty of the fire pits. Here are some basic structural components of an outdoor fire pit: Fill: This may refer to the firepit glass crystals, which are uniquely formulated to avoid the fuel from melting too quickly. These glass crystals are available in different colors, so they emanate different colors when they burn. Another material that is popularly used as pit fill is lava rock. Although, natural wood can also be used as a fuel, using these specially formulated kinds of fuel makes it easy to move the firepit around.
If spending time outside is a favorite activity, you may want to improve the experience with a comfortable firepit setting. 2) What is your budget? Firepits come in a variety of styles and sizes. Some are merely portable iron bowls you can find in a home improvement shop, while others are brick structures that require professional construction and installation. Some will burn wood, others work with gas. The type of firepit you want may not correspond with the money you are able to invest, so make sure you go over your finances before you make a firm decision. 3) Are there any obstacles to installing a fire shoppe? Having a place where you will have an open flame may affect your home insurance.
Seat distance from the firepit is critical. Too close and the fire will be too hot; too far away and the heat wont reach you. You can vary the distance with each seat but we found that for a pit 800mm in diameter the seats should be about 1m away from the pit. This allows people to walk in front of each other around the fire. Once the rock seats are in place the next job was to pour concrete around the pit and around the bottom of the seats so that the outside line of concrete joins all the stones about halfway. The back of the rocks protrudes out into what will become turf.
Its a bit tricky to get the heavy slabs in an exact circle with a consistent height but its best to prop them up and backfill with the gravel so that each stone is buried 150mm leaving a 450mm deep pit. The top of the granite should be 200mm above the surrounding ground level to allow for the concrete slab and paving. You could cut each stone lengthwise along one edge to make them fit flush with each other but it isnt necessary. The bottom of the pit was then paved to make shovelling out the ashes easier.