Henriette Firepit February 27th, 2018 - 13:39:22
Once youve figured out just what to do with the hole, lets look at some decorative edging. Again you can opt to just leave the sides bare. Leaving a gaping hole in the ground probably isnt the greatest idea, someone could trip and fall into the pit. So here are some edging options going again from least to most expensive. Use the dirt that you excavated from the pit to build a berm around the edge of the pit. Like with leaving the hole unlined, youll have to worry about wash out. The next method is to place large rounded stones around the perimeter. The stones can get expensive but youll only need a couple dozen to finish off the edge.
Cleaning and Maintenance 1. One of the most important considerations is to keep the burner free from obstruction. If you have gas logs you will want to periodically remove them so as to be able to inspect the burner. If the burner is dirty, clean it with a soft brush. Also remove any dirt or lint in this area. As you can see most of the safety tips provided are common sense. By staying alert to the potential dangers and keeping up on cleaning and maintenance, nothing can stop you from enjoying your outdoor fire!
Its a bit tricky to get the heavy slabs in an exact circle with a consistent height but its best to prop them up and backfill with the gravel so that each stone is buried 150mm leaving a 450mm deep pit. The top of the granite should be 200mm above the surrounding ground level to allow for the concrete slab and paving. You could cut each stone lengthwise along one edge to make them fit flush with each other but it isnt necessary. The bottom of the pit was then paved to make shovelling out the ashes easier.
Once youve dug the hole you have 2 options, staying natural or a liner. Both have advantages and disadvantages. Leaving the pit bare saves you time and money. Once youre done digging all that you need to do is edge the hole. The biggest disadvantage to this method is that any rainstorm can wash out the sides of the pit and make it unstable. If youve decided to line the firepit then you have a few options. The cheapest method is to pour gravel into the hole and press it into the sides. Its a cheap affordable way to ensure proper drainage. The most expensive option is to brick and mortar the entire hole, while leaving drain holes in the bottom. Its an attractive solution, and youll never have to worry about one of the sides washing out.