Henriette Firepit February 27th, 2018 - 11:06:03
Just like the kitchen indoors, an outdoor firepit is a magnetic gathering place for people at a party or family get-together on a cool evening. In this article I have described how to lay out and construct a permanent stone firepit. You can of course just have a bonfire with some deck chairs around it but a formal fireplace will provide more safety plus add value to your property. Materials: · 4 - 8 Large stones (600mm deep) with at least 1 flat side for fireside seats. Sandstone is perfect but basalt works well also · 10 granite slabs 600 x 300 x 80mm.· 25m2 random limestone or sandstone· 1m3 of 20mm drainage gravel· 90mm agriculture pipe (plastic perforated pipe covered in geotextile material)· 2.5m3 concrete· cement· brick sand.
The wedding location is outside in the fragrant, cool air of spring. After the ceremony and dinner, the guests mill about looking for something to do. The groom leads everyone to the pavilion where seats are set up around a blazing firepit. The guests murmur their pleasure, and will remember this wedding for years. Choosing the Most Suitable Outdoor Fireplace On the market today are many types, sizes and designs of firepits. The amount of help you have at your wedding, or the level DIY you posses, will dictate what kid of pit to choose. First, you will want to decide which type you want, gas or wood burning. A gas outdoor fireplace will allow easy lighting, and forego the chore of maintaining the fire. The main draw back is having to haul around propane tanks. Unless you choose purchase a cover for the tank, the sight of it could detract from the mood. A wood burning pit is traditional, and people like to add the wood to keep it going. Youll need to be sure to have ample wood for the size or number of pits you choose to buy.
Once youve figured out just what to do with the hole, lets look at some decorative edging. Again you can opt to just leave the sides bare. Leaving a gaping hole in the ground probably isnt the greatest idea, someone could trip and fall into the pit. So here are some edging options going again from least to most expensive. Use the dirt that you excavated from the pit to build a berm around the edge of the pit. Like with leaving the hole unlined, youll have to worry about wash out. The next method is to place large rounded stones around the perimeter. The stones can get expensive but youll only need a couple dozen to finish off the edge.
Once the stone lining was completed we used an excavator to place the large stone seats. Depending on the size of the stones they may have to be dug into the ground or set higher on gravel to give them an approximately consistent height. Bearing in mind that a comfortable adult seat height should be 300 - 400mm the stones need to conform to this measurement. By the time the concrete is poured and the paving laid the finished ground height will be 150mm higher than existing ground level, meaning that the rocks should stand 450 - 550mm above the ground.