Henriette Firepit February 21st, 2018 - 10:51:45
The style is important too, as it should fit the style of the wedding. There are casual design pits as well as modern and more formal. If youre grilling, there are outdoor fireplaces that allow for cooking, and table style pits that give you space right beside the fire to keep drinks and utensils. Choose a design and size that works for your number of guests. Most pits allow access from any side, which is ideal in this type of large gathering. The number of guests will dictate the size or number you will need. Decide if you want one or two large pits, or several smaller pits. This will depend on the number of guests and the possibility of family members that may not get along. In the latter case, youll definitely want more pits in order to keep certain guests separate.
Your next step is to start digging! Since youve already decided on the size of your firepit, all you have to do is dig an appropriately sized hole. Next, use bricks of the same height and place them at the surface level of the pit. From there, begin creating simple stacked rows, making sure to offset the vertical joints of each brick. When your pit has reached your desired and pre-planned height, youre ready to move on to the next step. Support the bricks you have laid by adding firmly packed soil around the area. You can also use gravel for the floor of the pit, smoothing as you add it in. Your final step is to add in top caps to the walls.
Procedure: First, we excavated a pit approximately 1metre (3 feet) in diameter and 800mm deep. The ground we were working on was very rocky so we used a backhoe and it was difficult to carve a smooth hole as you can see by the photos. Next we dug a drainage channel from the bottom of the hole to a lower point beyond the extent of the fire area. This was essential in this circumstance due to the heavy rainfall and the heavy soil. If your soil is porous it may not be necessary to provide drainage to the pit. In the channel we laid the plastic drainage pipe and covered it with gravel. Because we wanted to line the pit with the 600mm granite slabs we placed extra gravel in the bottom of the pit to set the stones on upright in a circle.
Seat distance from the firepit is critical. Too close and the fire will be too hot; too far away and the heat wont reach you. You can vary the distance with each seat but we found that for a pit 800mm in diameter the seats should be about 1m away from the pit. This allows people to walk in front of each other around the fire. Once the rock seats are in place the next job was to pour concrete around the pit and around the bottom of the seats so that the outside line of concrete joins all the stones about halfway. The back of the rocks protrudes out into what will become turf.