Ila Benson Firepit February 19th, 2018 - 09:48:50
As they are portable, outdoor firepits are easy to move from one place to another. You can carry your set to a picnic spot far from home without much difficulty. There are various accessories that can come with an outdoor firepit. You can buy them to enhance the safety and beauty of the fire pits. Here are some basic structural components of an outdoor fire pit: Fill: This may refer to the firepit glass crystals, which are uniquely formulated to avoid the fuel from melting too quickly. These glass crystals are available in different colors, so they emanate different colors when they burn. Another material that is popularly used as pit fill is lava rock. Although, natural wood can also be used as a fuel, using these specially formulated kinds of fuel makes it easy to move the firepit around.
Your first step is, of course, to choose where your firepit will go. Pick an area that doesnt present a fire hazard and that will be comfortable for you and your guests to sit and relax. If, for example, you know one part of your yard is prone to mosquitoes, you would certainly want to avoid that spot. Just think practically, and you should be fine! When youve decided on the size and location of your pit, mark it using chalk or paint. If there is sod in the area, youll need to remove it, and you should also use a pre-emergent herbicide in order to prevent grass from growing in that area again.
Procedure: First, we excavated a pit approximately 1metre (3 feet) in diameter and 800mm deep. The ground we were working on was very rocky so we used a backhoe and it was difficult to carve a smooth hole as you can see by the photos. Next we dug a drainage channel from the bottom of the hole to a lower point beyond the extent of the fire area. This was essential in this circumstance due to the heavy rainfall and the heavy soil. If your soil is porous it may not be necessary to provide drainage to the pit. In the channel we laid the plastic drainage pipe and covered it with gravel. Because we wanted to line the pit with the 600mm granite slabs we placed extra gravel in the bottom of the pit to set the stones on upright in a circle.
You will want to use an appropriate adhesive material, such as mortar, to keep the caps firmly in place. Be sure to apply the caps only to dry surfaces and to keep them level during the process. Believe it or not, once youve done this, youre ready to try out your new firepit! Make sure to take proper care of your firepit so that you can enjoy it for many years to come. Always clean the ashes from your pit one day after use. If you have decided to paint your pit (using fire resistant paint, of course), it may need touch-ups from time to time to continue looking its best. Make sure that water is never used to put out fires, as this can cause the firepit to break down faster. Youll also want to invest in a good firepit cover for when the pit is not in use.