Henriette Firepit February 27th, 2018 - 11:17:38
Firepit Tools: These tools are mainly used to tend the fires. You can buy a set or can just order fire poker and a pair of tongs, used for tending the fire and to move the logs, if they have been used to light the fire. Outdoor Firepit Screens: These screens are wire mesh devices attached to the outer edge of the outdoor firepit. The mesh is used to prevent fire and ashes from spilling out of the pit. There are various designs that you can get with the meshes. These meshes can be used in different ways when the pit is turned into an oven. You can feel the heat while keeping safe.
Once the stone lining was completed we used an excavator to place the large stone seats. Depending on the size of the stones they may have to be dug into the ground or set higher on gravel to give them an approximately consistent height. Bearing in mind that a comfortable adult seat height should be 300 - 400mm the stones need to conform to this measurement. By the time the concrete is poured and the paving laid the finished ground height will be 150mm higher than existing ground level, meaning that the rocks should stand 450 - 550mm above the ground.
Gas Firepit Safety 1. You can help prevent accidental fires by keeping the area around your firepit free from combustible materials. This can include cleaning materials like mops, brooms, newspapers but more importantly, gasoline and cleaning fluids. 2. Inspect and clean burners regularly. Insects such as spiders can actually nest in the burners and block air flow. If this happens a fire can start behind the valve panel. 3. Be sure to keep electric cords and power supplies away from the fire pit. 4. Dont use your gas fire pit in a windy area. If you need to do so create a windbreak. 5. Never line a gas firepit with tin foil. 6. Dont use your firepit as a storage area for flammable materials or plastic items which can ignite. 7. Never leave children unattended around fire pit when in use.
Procedure: First, we excavated a pit approximately 1metre (3 feet) in diameter and 800mm deep. The ground we were working on was very rocky so we used a backhoe and it was difficult to carve a smooth hole as you can see by the photos. Next we dug a drainage channel from the bottom of the hole to a lower point beyond the extent of the fire area. This was essential in this circumstance due to the heavy rainfall and the heavy soil. If your soil is porous it may not be necessary to provide drainage to the pit. In the channel we laid the plastic drainage pipe and covered it with gravel. Because we wanted to line the pit with the 600mm granite slabs we placed extra gravel in the bottom of the pit to set the stones on upright in a circle.