Henriette Firepit February 27th, 2018 - 11:16:48
Firepit Tools: These tools are mainly used to tend the fires. You can buy a set or can just order fire poker and a pair of tongs, used for tending the fire and to move the logs, if they have been used to light the fire. Outdoor Firepit Screens: These screens are wire mesh devices attached to the outer edge of the outdoor firepit. The mesh is used to prevent fire and ashes from spilling out of the pit. There are various designs that you can get with the meshes. These meshes can be used in different ways when the pit is turned into an oven. You can feel the heat while keeping safe.
Its a bit tricky to get the heavy slabs in an exact circle with a consistent height but its best to prop them up and backfill with the gravel so that each stone is buried 150mm leaving a 450mm deep pit. The top of the granite should be 200mm above the surrounding ground level to allow for the concrete slab and paving. You could cut each stone lengthwise along one edge to make them fit flush with each other but it isnt necessary. The bottom of the pit was then paved to make shovelling out the ashes easier.
The warm summer months bring memories of romantic walks along the beach, and pleasant afternoons in the sun. Summer gives way to the chilly days of fall. Chilly brisk air pinks the nose, and makes you snuggle down deep into your parka. The cool days become chilly nights. There is no better time to bring your date close to you than in front of a warm, crackling fire. Finding a Firepit to Suit You Digging a hole in the ground and building a fire in it only seems like the most practical way to go. Its cheap, and looks that way too. Today, there are so many commercial firepits available that theres no excuse to ruin your lawn. Not only is a store bought pit far more attractive than a dirt pit, but it can be moved to any point on your property. Maybe you want a location for a little privacy or maybe youd just like to get out of the wind.
Procedure: First, we excavated a pit approximately 1metre (3 feet) in diameter and 800mm deep. The ground we were working on was very rocky so we used a backhoe and it was difficult to carve a smooth hole as you can see by the photos. Next we dug a drainage channel from the bottom of the hole to a lower point beyond the extent of the fire area. This was essential in this circumstance due to the heavy rainfall and the heavy soil. If your soil is porous it may not be necessary to provide drainage to the pit. In the channel we laid the plastic drainage pipe and covered it with gravel. Because we wanted to line the pit with the 600mm granite slabs we placed extra gravel in the bottom of the pit to set the stones on upright in a circle.