Henriette Firepit February 27th, 2018 - 11:16:26
If youre looking to buy a copper firepit, you will need to decide what size is right for you. There are many sizes and varieties to choose from, you will need to figure out what is best for your situation. If you have a larger backyard or deck you might want to have a large firepit. A smaller firepit would probably be better for someone with a smaller space, such as a balcony at an apartment building. Looking into the options will help you to make the best decision. A copper firepit can come in a 24 or a 26 inch size. That is small enough so that it wont take up a lot of room. With a small firepit you can still have the coziness of a fire in a limited amount of space. Imagine sitting on the balcony in front of the fire, just the two of you.
Once youve figured out just what to do with the hole, lets look at some decorative edging. Again you can opt to just leave the sides bare. Leaving a gaping hole in the ground probably isnt the greatest idea, someone could trip and fall into the pit. So here are some edging options going again from least to most expensive. Use the dirt that you excavated from the pit to build a berm around the edge of the pit. Like with leaving the hole unlined, youll have to worry about wash out. The next method is to place large rounded stones around the perimeter. The stones can get expensive but youll only need a couple dozen to finish off the edge.
Firepits are an excellent, inexpensive way to enjoy the great outdoors all year long. In the winter and fall months, there is nothing better than cuddling up outside around a cozy, warm firepit. Even during the cool summer and spring evenings, you can build a small fire to create atmosphere and to make the most out of the evening. Whether you want to enjoy your firepit with your family, with that special someone, or with a whole group of friends, you dont have to spend a fortune to install one or to buy one. In fact, you can easily make your own firepit just by following a few simple steps.
Procedure: First, we excavated a pit approximately 1metre (3 feet) in diameter and 800mm deep. The ground we were working on was very rocky so we used a backhoe and it was difficult to carve a smooth hole as you can see by the photos. Next we dug a drainage channel from the bottom of the hole to a lower point beyond the extent of the fire area. This was essential in this circumstance due to the heavy rainfall and the heavy soil. If your soil is porous it may not be necessary to provide drainage to the pit. In the channel we laid the plastic drainage pipe and covered it with gravel. Because we wanted to line the pit with the 600mm granite slabs we placed extra gravel in the bottom of the pit to set the stones on upright in a circle.