Henriette Firepit February 21st, 2018 - 11:09:40
Seat distance from the firepit is critical. Too close and the fire will be too hot; too far away and the heat wont reach you. You can vary the distance with each seat but we found that for a pit 800mm in diameter the seats should be about 1m away from the pit. This allows people to walk in front of each other around the fire. Once the rock seats are in place the next job was to pour concrete around the pit and around the bottom of the seats so that the outside line of concrete joins all the stones about halfway. The back of the rocks protrudes out into what will become turf.
Once youve figured out just what to do with the hole, lets look at some decorative edging. Again you can opt to just leave the sides bare. Leaving a gaping hole in the ground probably isnt the greatest idea, someone could trip and fall into the pit. So here are some edging options going again from least to most expensive. Use the dirt that you excavated from the pit to build a berm around the edge of the pit. Like with leaving the hole unlined, youll have to worry about wash out. The next method is to place large rounded stones around the perimeter. The stones can get expensive but youll only need a couple dozen to finish off the edge.
Cleaning and Maintenance 1. One of the most important considerations is to keep the burner free from obstruction. If you have gas logs you will want to periodically remove them so as to be able to inspect the burner. If the burner is dirty, clean it with a soft brush. Also remove any dirt or lint in this area. As you can see most of the safety tips provided are common sense. By staying alert to the potential dangers and keeping up on cleaning and maintenance, nothing can stop you from enjoying your outdoor fire!
Once the stone lining was completed we used an excavator to place the large stone seats. Depending on the size of the stones they may have to be dug into the ground or set higher on gravel to give them an approximately consistent height. Bearing in mind that a comfortable adult seat height should be 300 - 400mm the stones need to conform to this measurement. By the time the concrete is poured and the paving laid the finished ground height will be 150mm higher than existing ground level, meaning that the rocks should stand 450 - 550mm above the ground.