Henriette Firepit February 21st, 2018 - 11:08:47
As they are portable, outdoor firepits are easy to move from one place to another. You can carry your set to a picnic spot far from home without much difficulty. There are various accessories that can come with an outdoor firepit. You can buy them to enhance the safety and beauty of the fire pits. Here are some basic structural components of an outdoor fire pit: Fill: This may refer to the firepit glass crystals, which are uniquely formulated to avoid the fuel from melting too quickly. These glass crystals are available in different colors, so they emanate different colors when they burn. Another material that is popularly used as pit fill is lava rock. Although, natural wood can also be used as a fuel, using these specially formulated kinds of fuel makes it easy to move the firepit around.
Once youve figured out just what to do with the hole, lets look at some decorative edging. Again you can opt to just leave the sides bare. Leaving a gaping hole in the ground probably isnt the greatest idea, someone could trip and fall into the pit. So here are some edging options going again from least to most expensive. Use the dirt that you excavated from the pit to build a berm around the edge of the pit. Like with leaving the hole unlined, youll have to worry about wash out. The next method is to place large rounded stones around the perimeter. The stones can get expensive but youll only need a couple dozen to finish off the edge.
Procedure: First, we excavated a pit approximately 1metre (3 feet) in diameter and 800mm deep. The ground we were working on was very rocky so we used a backhoe and it was difficult to carve a smooth hole as you can see by the photos. Next we dug a drainage channel from the bottom of the hole to a lower point beyond the extent of the fire area. This was essential in this circumstance due to the heavy rainfall and the heavy soil. If your soil is porous it may not be necessary to provide drainage to the pit. In the channel we laid the plastic drainage pipe and covered it with gravel. Because we wanted to line the pit with the 600mm granite slabs we placed extra gravel in the bottom of the pit to set the stones on upright in a circle.
Your next step is to start digging! Since youve already decided on the size of your firepit, all you have to do is dig an appropriately sized hole. Next, use bricks of the same height and place them at the surface level of the pit. From there, begin creating simple stacked rows, making sure to offset the vertical joints of each brick. When your pit has reached your desired and pre-planned height, youre ready to move on to the next step. Support the bricks you have laid by adding firmly packed soil around the area. You can also use gravel for the floor of the pit, smoothing as you add it in. Your final step is to add in top caps to the walls.