Home / Fireplace / lennox gas fireplace photo ideas / Lennox Direct Vent Gas Fireplace Manual Lennox C33 Manual Lennox Direct Vent Fireplace Reviews Kozy Heat Chaska 34 Reviews Lennox Hearth Products Service
Henriette Fireplace February 15th, 2018 - 10:15:02
The next step is to clean those well-used fireplace tools and fireplace grate. Black soot and resin can easily build up on your tools and can make them unsightly and grungy-looking. Here are a few simple steps to help bring back their original luster and shine. Take your fireplace grate and tools outside and give them a good hosing down. This will quickly remove all of the loose soot and dirt from the surface. For the fireplace grate, fill a bucket with hot water and a small amount of abrasive cleaner. Scrub with a steel wool pad to remove the caked on resin and soot. You may need to use a stiff-bristled brush to get the really bad parts. For the fireplace tools, use hot water and a small amount of ammonia cleaner. Avoid using abrasives, as these may scratch the finish on your tools. You may use a scrub brush to get the stubborn dirt particles, but use caution so as not to damage the surface.
This is not the case, heat from your fireplace will radiate out through the glass even if the glass-doors are closed, so a good way to use your glass-doors is to burn the fireplace with the glass-doors open and the safety screen closed. In this way you have all the beauty and ambience of your fire before you. If your fireplace is equipped with outside air or make up air you can also burn the fireplace with the glass doors shut and the safety screen open, in this mode you will be able to see your beautiful fire and feel the radiant heat, but not be losing any of the air in the room up the chimney. Make up air or outside air can be installed on most fireplaces if you dont have it in your fireplace now. These two things will also overcome the reasons that some fireplaces smoke, and also why your fireplace has a drafty smokey smell to it when it is not being used. Just for those two reasons every fireplace should have glass-doors installed on them.
If you decide that sitting next to the fireplace is the way to go, you will need to make sure you have enough chimney rods to span the entire length of your chimney. As you are sitting next to your fireplace, push your brush up through the flue. Continue to add more brush rods as needed until the brush is at the top of the chimney. As you pull the brush back down, you will need to make a back and forth motion to really scrub the creosote off the walls of the chimney. Be sure to shield your eyes, as some of this loosened creosote may fall into the firebox.
Gas fireplace inserts utilize natural gas or liquid propane as the fuel source and consist of a gas log set installed into a steel or cast iron stove and are usually sealed on the front with glass. Most gas inserts have fans or blowers that automatically circulate the heat. Gas inserts are available with remote controls, wall switches or wall-mounted thermostats. Wood-burning fireplace inserts use firewood as the fuel source. Wood inserts come with fans or blowers that automatically circulate the heat. Wood burning inserts would typically include an operable glass door in the front to allow for loading of firewood and flame viewing. Wood inserts vary in size of flame viewing area (the bigger the better) and maximum log length that can be inserted into the stove for burning.