Henriette Fireplace February 13th, 2018 - 10:44:54
There are actually several good ways to clean out a chimney. One is to purchase a chimney brush that matches your size and type of chimney. These brushes are specially designed for cleaning out chimneys, but you need to make sure you have the right size for your specific chimney. Also, if you have a brick and mortar chimney you should use a wire brush, whereas if your chimney is prefab, you should use a brush with poly bristles. The shape of your chimney is also important in considering which brush to buy. Some chimneys are square or rectangle, while others are round. Once you have determined which brush is best for your chimney, you need to decide whether you are more comfortable climbing up on top of your roof to clean or sitting next to your fireplace.
The best reason I have saved for last and that is, your fireplace is costing you heat loss all day and night even when your not using it. The reason is that your damper in your fireplace is not airtight they are made that way to maintain a certain amount of clearance even when they are closed. So If you have a fireplace that does not have a glass-door you are wasting energy, up and out the chimney. In this article its easy to see how you can get more heat out of your fireplace with just a few small changes, that will let you burn outside air instead of the air that you already paid to heat, and by installing glass-doors to stop heat loss.
Pellet fireplace inserts use wood pellets or other types of pellets (corn based, soy based, etc.) as the fuel source. Pellet fireplace inserts come with fans or blowers that automatically circulate the heat. Pellet-Burning Hearth Appliances Pellet-burning hearth appliances are simpler to operate and more convenient than other wood-burning appliances. In fact, they are almost as easy to use as gas, oil or electric heaters. Pellet stoves and pellet inserts burn wood pellets or compressed wood. Pellet-burning hearth appliances are loaded with pellets through a hopper and the rate of burn is controlled by an electronic circuit board that is typically controlled by burn settings or a thermostat. Most pellet appliances have at least two burn settings and some new models use thermostats to control the fire.
If you decide that sitting next to the fireplace is the way to go, you will need to make sure you have enough chimney rods to span the entire length of your chimney. As you are sitting next to your fireplace, push your brush up through the flue. Continue to add more brush rods as needed until the brush is at the top of the chimney. As you pull the brush back down, you will need to make a back and forth motion to really scrub the creosote off the walls of the chimney. Be sure to shield your eyes, as some of this loosened creosote may fall into the firebox.