Henriette Firepit February 27th, 2018 - 11:07:06
Once youve dug the hole you have 2 options, staying natural or a liner. Both have advantages and disadvantages. Leaving the pit bare saves you time and money. Once youre done digging all that you need to do is edge the hole. The biggest disadvantage to this method is that any rainstorm can wash out the sides of the pit and make it unstable. If youve decided to line the firepit then you have a few options. The cheapest method is to pour gravel into the hole and press it into the sides. Its a cheap affordable way to ensure proper drainage. The most expensive option is to brick and mortar the entire hole, while leaving drain holes in the bottom. Its an attractive solution, and youll never have to worry about one of the sides washing out.
Depending on how the weather turns, you may find that you enjoy sitting in the backyard at specific times of the year. It is not uncommon to consider different ways to improve your back patio or deck - maybe youve considered a gazebo or garden, or even a firepit to keep yourself warm on cooler evenings. Do you need a firepit to enhance your backyard entertaining, however? It can be a solid investment or a folly, but if you consider the pros and cons you will find youve made the right decision for home improvement. Here are a few points to consider if you have thought about installing a fire shoppe in your backyard: 1) How often do you sit out in the backyard? Do you think the addition of a firepit will inspire you to spend more time outside? The good thing about firepits is that you can use them year round - for cozy conversations during the fall and winter and marshmallow toasting and hot dog roasting in the summer.
Once the stone lining was completed we used an excavator to place the large stone seats. Depending on the size of the stones they may have to be dug into the ground or set higher on gravel to give them an approximately consistent height. Bearing in mind that a comfortable adult seat height should be 300 - 400mm the stones need to conform to this measurement. By the time the concrete is poured and the paving laid the finished ground height will be 150mm higher than existing ground level, meaning that the rocks should stand 450 - 550mm above the ground.
Procedure: First, we excavated a pit approximately 1metre (3 feet) in diameter and 800mm deep. The ground we were working on was very rocky so we used a backhoe and it was difficult to carve a smooth hole as you can see by the photos. Next we dug a drainage channel from the bottom of the hole to a lower point beyond the extent of the fire area. This was essential in this circumstance due to the heavy rainfall and the heavy soil. If your soil is porous it may not be necessary to provide drainage to the pit. In the channel we laid the plastic drainage pipe and covered it with gravel. Because we wanted to line the pit with the 600mm granite slabs we placed extra gravel in the bottom of the pit to set the stones on upright in a circle.