Henriette Firepit February 27th, 2018 - 11:09:42
Once the stone lining was completed we used an excavator to place the large stone seats. Depending on the size of the stones they may have to be dug into the ground or set higher on gravel to give them an approximately consistent height. Bearing in mind that a comfortable adult seat height should be 300 - 400mm the stones need to conform to this measurement. By the time the concrete is poured and the paving laid the finished ground height will be 150mm higher than existing ground level, meaning that the rocks should stand 450 - 550mm above the ground.
Also, if you live in a condo or other planned community there may be restrictions to what you can have installed in your yard area. Check with your insurance company and HOA or board to see if any regulations prevent you from setting up something. If nothing stands in the way of your plan to enhance your backyard relaxation, you next want to research what kind of pit you want. Do you have an existing deck or patio? You may be able to build onto it and install a gas line for it. If not, you may wish to landscape the backyard altogether with the firepit as the focus. A local contractor or backyard leisure store can offer you many ideas.
Firepit Tools: These tools are mainly used to tend the fires. You can buy a set or can just order fire poker and a pair of tongs, used for tending the fire and to move the logs, if they have been used to light the fire. Outdoor Firepit Screens: These screens are wire mesh devices attached to the outer edge of the outdoor firepit. The mesh is used to prevent fire and ashes from spilling out of the pit. There are various designs that you can get with the meshes. These meshes can be used in different ways when the pit is turned into an oven. You can feel the heat while keeping safe.
The reinforced concrete was poured to a depth of 100mm, allowing the firepit lining stones to protrude 100mm above it, with a slope of 1:100 away from the pit. Letting the concrete cure for a week, we then laid out random limestone pieces to gauge the best arrangement. Random stone comes in varying thicknesses and sizes and takes a great deal of patience to lay properly. You can simply start laying and choose matching pieces, filling in the many small gaps with small pieces but we prefer to shape the stones so that gaps are consistent and the small pieces are minimal. Once the stone was shaped and mortared down the gaps were grouted with mortar, coloured to match the stone. The final thing was sealing the limestone with a good quality stone sealant. And there is your party feature! When you light a fire and let it burn for a few hours the limestone patio begins to heat up and radiate to the surrounding seats making a very cosy spot on a cool autumn evening.