Henriette Firepit February 25th, 2018 - 11:43:47
Its a bit tricky to get the heavy slabs in an exact circle with a consistent height but its best to prop them up and backfill with the gravel so that each stone is buried 150mm leaving a 450mm deep pit. The top of the granite should be 200mm above the surrounding ground level to allow for the concrete slab and paving. You could cut each stone lengthwise along one edge to make them fit flush with each other but it isnt necessary. The bottom of the pit was then paved to make shovelling out the ashes easier.
There are other safety issues that you also need to consider when lighting a fire in a copper firepit. Never, ever leave a fire unattended, even for just a moment. Also make sure that any children that are with you keep a safe distance from the fire. Do not allow children to put anything into a burning fire, even if they claim that they know what they are doing. Dont allow children to stir the fire or to add wood or charcoal. Also keep a bucket of water handy in case you need to put the fire out quickly. With a few precautions, you can happily enjoy your new copper firepit for years to come. A little bit of common sense goes a long way. Remember that if something seems like a bad idea, it probably is. Fire can be dangerous, but it doesnt have to be. Use care and make sure that you dont get too close. Follow all directions that came with your firepit. Youll be glad that you did.
You will want to use an appropriate adhesive material, such as mortar, to keep the caps firmly in place. Be sure to apply the caps only to dry surfaces and to keep them level during the process. Believe it or not, once youve done this, youre ready to try out your new firepit! Make sure to take proper care of your firepit so that you can enjoy it for many years to come. Always clean the ashes from your pit one day after use. If you have decided to paint your pit (using fire resistant paint, of course), it may need touch-ups from time to time to continue looking its best. Make sure that water is never used to put out fires, as this can cause the firepit to break down faster. Youll also want to invest in a good firepit cover for when the pit is not in use.
Once the stone lining was completed we used an excavator to place the large stone seats. Depending on the size of the stones they may have to be dug into the ground or set higher on gravel to give them an approximately consistent height. Bearing in mind that a comfortable adult seat height should be 300 - 400mm the stones need to conform to this measurement. By the time the concrete is poured and the paving laid the finished ground height will be 150mm higher than existing ground level, meaning that the rocks should stand 450 - 550mm above the ground.