Home / Fireplace / fascinating gas fireplace insert cost pictures inspirations / How To Install A Vent Free Gas Fireplace Insert Cost To Install Gas Logs In Existing Fireplace How Much Does A Gas Fireplace Cost To Run Gas Fireplace Installers
Henriette Fireplace February 13th, 2018 - 10:44:05
Once you have finished cleaning your chimney, the next step in cleaning your fireplace to prepare it for the coming warmer months, is to clean out the firebox. You will need to give your firebox walls a good brushing with a nice stiff brush. Knock down all the loose soot and ash that has gotten stuck to the brick walls and flue. Remove your fireplace grate and set it to the side on a newspaper. Keep it from touching your finished flooring, as it will leave a nice sooty footprint. You will clean this and your other fireplace tools in the next step. Using your fireplace shovel, you will need to scoop out as much of the completely cooled ash and the chunks of unburned wood as you can. Using your fireplace brush, sweep the remainder of the ash onto your shovel and into an ash bucket.
While these screens will not stop a rolling log they will protect areas outside the hearth from flying sparks from popping wood sap. One of the greatest advantages to mesh screens is that they require no extra space or braces and do not extend past the flush face of the fireplace. Another very common type of fireplace screen is made of iron, brass or steel and mounts in front of or on the hearth free-standing in front of the firebox. These fireplace screens can be a simple flat screen, might be free standing on leg-brackets and could be the more common three-sided screen. Three-sided screens have a center section that spans the width of the fireplace. The two sides are hinged to turn at a thirty to forty-five degree angle thus holding the screen plum straight up. The fireplace screen can have fireplace tools, candles and all manner of artistic décor built into the design.
If you decide that sitting next to the fireplace is the way to go, you will need to make sure you have enough chimney rods to span the entire length of your chimney. As you are sitting next to your fireplace, push your brush up through the flue. Continue to add more brush rods as needed until the brush is at the top of the chimney. As you pull the brush back down, you will need to make a back and forth motion to really scrub the creosote off the walls of the chimney. Be sure to shield your eyes, as some of this loosened creosote may fall into the firebox.
This is not the case, heat from your fireplace will radiate out through the glass even if the glass-doors are closed, so a good way to use your glass-doors is to burn the fireplace with the glass-doors open and the safety screen closed. In this way you have all the beauty and ambience of your fire before you. If your fireplace is equipped with outside air or make up air you can also burn the fireplace with the glass doors shut and the safety screen open, in this mode you will be able to see your beautiful fire and feel the radiant heat, but not be losing any of the air in the room up the chimney. Make up air or outside air can be installed on most fireplaces if you dont have it in your fireplace now. These two things will also overcome the reasons that some fireplaces smoke, and also why your fireplace has a drafty smokey smell to it when it is not being used. Just for those two reasons every fireplace should have glass-doors installed on them.