Henriette Firepit February 22nd, 2018 - 11:50:04
Firepit Tools: These tools are mainly used to tend the fires. You can buy a set or can just order fire poker and a pair of tongs, used for tending the fire and to move the logs, if they have been used to light the fire. Outdoor Firepit Screens: These screens are wire mesh devices attached to the outer edge of the outdoor firepit. The mesh is used to prevent fire and ashes from spilling out of the pit. There are various designs that you can get with the meshes. These meshes can be used in different ways when the pit is turned into an oven. You can feel the heat while keeping safe.
If youre looking to buy a copper firepit, you will need to decide what size is right for you. There are many sizes and varieties to choose from, you will need to figure out what is best for your situation. If you have a larger backyard or deck you might want to have a large firepit. A smaller firepit would probably be better for someone with a smaller space, such as a balcony at an apartment building. Looking into the options will help you to make the best decision. A copper firepit can come in a 24 or a 26 inch size. That is small enough so that it wont take up a lot of room. With a small firepit you can still have the coziness of a fire in a limited amount of space. Imagine sitting on the balcony in front of the fire, just the two of you.
You will want to use an appropriate adhesive material, such as mortar, to keep the caps firmly in place. Be sure to apply the caps only to dry surfaces and to keep them level during the process. Believe it or not, once youve done this, youre ready to try out your new firepit! Make sure to take proper care of your firepit so that you can enjoy it for many years to come. Always clean the ashes from your pit one day after use. If you have decided to paint your pit (using fire resistant paint, of course), it may need touch-ups from time to time to continue looking its best. Make sure that water is never used to put out fires, as this can cause the firepit to break down faster. Youll also want to invest in a good firepit cover for when the pit is not in use.
Its a bit tricky to get the heavy slabs in an exact circle with a consistent height but its best to prop them up and backfill with the gravel so that each stone is buried 150mm leaving a 450mm deep pit. The top of the granite should be 200mm above the surrounding ground level to allow for the concrete slab and paving. You could cut each stone lengthwise along one edge to make them fit flush with each other but it isnt necessary. The bottom of the pit was then paved to make shovelling out the ashes easier.