Henriette Firepit February 21st, 2018 - 10:58:17
Once the stone lining was completed we used an excavator to place the large stone seats. Depending on the size of the stones they may have to be dug into the ground or set higher on gravel to give them an approximately consistent height. Bearing in mind that a comfortable adult seat height should be 300 - 400mm the stones need to conform to this measurement. By the time the concrete is poured and the paving laid the finished ground height will be 150mm higher than existing ground level, meaning that the rocks should stand 450 - 550mm above the ground.
Firepit Tools: These tools are mainly used to tend the fires. You can buy a set or can just order fire poker and a pair of tongs, used for tending the fire and to move the logs, if they have been used to light the fire. Outdoor Firepit Screens: These screens are wire mesh devices attached to the outer edge of the outdoor firepit. The mesh is used to prevent fire and ashes from spilling out of the pit. There are various designs that you can get with the meshes. These meshes can be used in different ways when the pit is turned into an oven. You can feel the heat while keeping safe.
If youre looking to buy a copper firepit, you will need to decide what size is right for you. There are many sizes and varieties to choose from, you will need to figure out what is best for your situation. If you have a larger backyard or deck you might want to have a large firepit. A smaller firepit would probably be better for someone with a smaller space, such as a balcony at an apartment building. Looking into the options will help you to make the best decision. A copper firepit can come in a 24 or a 26 inch size. That is small enough so that it wont take up a lot of room. With a small firepit you can still have the coziness of a fire in a limited amount of space. Imagine sitting on the balcony in front of the fire, just the two of you.
Procedure: First, we excavated a pit approximately 1metre (3 feet) in diameter and 800mm deep. The ground we were working on was very rocky so we used a backhoe and it was difficult to carve a smooth hole as you can see by the photos. Next we dug a drainage channel from the bottom of the hole to a lower point beyond the extent of the fire area. This was essential in this circumstance due to the heavy rainfall and the heavy soil. If your soil is porous it may not be necessary to provide drainage to the pit. In the channel we laid the plastic drainage pipe and covered it with gravel. Because we wanted to line the pit with the 600mm granite slabs we placed extra gravel in the bottom of the pit to set the stones on upright in a circle.